The Ford Barn - View Single Post

Bluebell · 03-28-2022, 03:46 AM

As I remember, you drill the impellor off, and then press the bearing out from the back. Then it is easy to set up to press off the pulley. I'm talking about a Ford bearing type (truck) pump as an example.
This reamer is just to give you a flat clean surface for the seal to run against, similar to one used to repair the seat in a water tap.

03-28-2022, 03:46 AM	#8
Bluebell Senior Member Join Date: Nov 2012 Location: Tauranga, New Zealand Posts: 726	Re: Water pump resurfacer tool As I remember, you drill the impellor off, and then press the bearing out from the back. Then it is easy to set up to press off the pulley. I'm talking about a Ford bearing type (truck) pump as an example. This reamer is just to give you a flat clean surface for the seal to run against, similar to one used to repair the seat in a water tap.