The Ford Barn - View Single Post

Ratchet · 11-17-2021, 10:02 PM

Well my Model T is going to get some TLC most of the parts needed should be here tomorrow except for a Stipe 280 cam which no one has at the moment. The wiring in my vehicle needs to be replaced the insulation is brittle so I don't want to touch it I afraid insulation will break and fall off. I got lucky with the exhaust flange nut since the exhaust pipe flange broke off and was wired in place so I was able heat and free the nut up. I cut the remaining flange off the exhaust pipe, installed the nut on the pipe and made a new flange. I will be applying lots of antisieze during assembly.

The fun conitnues!

11-17-2021, 10:02 PM	#10
Ratchet Junior Member Join Date: Nov 2021 Location: Hamilton, Ontario, Canada Posts: 22	Re: Ignition Distributor Upgrade Well my Model T is going to get some TLC most of the parts needed should be here tomorrow except for a Stipe 280 cam which no one has at the moment. The wiring in my vehicle needs to be replaced the insulation is brittle so I don't want to touch it I afraid insulation will break and fall off. I got lucky with the exhaust flange nut since the exhaust pipe flange broke off and was wired in place so I was able heat and free the nut up. I cut the remaining flange off the exhaust pipe, installed the nut on the pipe and made a new flange. I will be applying lots of antisieze during assembly. The fun conitnues!