The Ford Barn - View Single Post

Bryan Thompson · 05-09-2021, 08:26 AM

Disconnect the shift lever from the unit.
Hit the shift mechanism on the unit with a hammer. Driving it in.
If it still pops out it is the unit, not the linkage.
These were Steve's directions.

05-09-2021, 08:26 AM	#10
Bryan Thompson Junior Member Join Date: Oct 2014 Location: Westminster, CA Posts: 14	Re: Mitchell Overdrive problem Disconnect the shift lever from the unit. Hit the shift mechanism on the unit with a hammer. Driving it in. If it still pops out it is the unit, not the linkage. These were Steve's directions.