Re: Mitchell Overdrive problem
Del,
I had the same problem. It turned out that my linkage was not allowing the drive to fully engage. Check your linkage. One way to check would be to disconnect the linkage, put the drive in high range directly at the unit, and then take a drive. I solved my problem by adjusting the linkage.
__________________
A is for apple, green as the sky.
Step on the gas, for tomorrow I die.
Forget the brakes, they really don't work.
The clutch always sticks, and starts with a jerk.
My car grows red hair, and flies through the air.
Driving's a blast, a blast from the past.
|