The Ford Barn - View Single Post

SAJ · 08-26-2020, 05:59 PM

Brett, we did not get a tool post grinder with this behemoth. But there was one listed in the pre-war catalogue.
The machine has been "rescued" from the scrap heap so may never be used properly, but we may refacea flywheel etc just for fun. The 4 jaw chuck is too heavy for our 1/2 ton jib crane shown lifting the motor.
SAJ in NZ

08-26-2020, 05:59 PM	#23
SAJ Senior Member Join Date: Jul 2010 Location: Auckland, New Zealand Posts: 522	Re: Crankshaft Counterbalance Weight Brett, we did not get a tool post grinder with this behemoth. But there was one listed in the pre-war catalogue. The machine has been "rescued" from the scrap heap so may never be used properly, but we may refacea flywheel etc just for fun. The 4 jaw chuck is too heavy for our 1/2 ton jib crane shown lifting the motor. SAJ in NZ