Quote:
Originally Posted by grumppyoldman
I got my new module yesterday, called pertronix and talked to a service tech. He told me to run a ground wire from battery neg. to dist. housing with 12 volts on pos. side of coil and it should fire up. No spark I left the old module in for that test to see if it was good before changing it out. Had to quit because of weather, will try again tomorrow if storm has passed. 50ford the module on my Ignitor 2 has no slots in the mounting screw holes for adjusting the gap. The module mounts on a C shaped plate that mounts to a round plate in top of the dist. with no adjustment in either for setting gap. Al
|
Maybe the adjustment is factory set? I don't know. My dist is OEM and maybe that is the difference. Would have to talk to their tech folks to find out. This whole thing is very odd so what are we missing??