The Ford Barn - View Single Post

flatjack9 · 04-26-2020, 10:13 PM

Set the head on and see which studs are offending. Run a nut on the stud and tap it over until it aligns. Go to next, etc. I would not enlarge the holes in the heads.

04-26-2020, 10:13 PM	#8
flatjack9 Senior Member Join Date: May 2010 Location: Oshkosh, Wi Posts: 4,544	Re: cylinder head studs Set the head on and see which studs are offending. Run a nut on the stud and tap it over until it aligns. Go to next, etc. I would not enlarge the holes in the heads.