The Ford Barn - View Single Post

51 MERC-CT · 02-05-2020, 01:12 PM

Made one some time ago for an 8BA cast bell out of hardware store 1/32" bare sheet stock.
The original is not pressed in, it is slip fit with the inner edge flared to secure.
Rivets were used to serve the same purpose as the factory bead-stop.

02-05-2020, 01:12 PM	#12
51 MERC-CT Senior Member Join Date: May 2010 Location: East Hartford, Ct Posts: 5,898	Re: Starter Drive Cover Made one some time ago for an 8BA cast bell out of hardware store 1/32" bare sheet stock. The original is not pressed in, it is slip fit with the inner edge flared to secure. Rivets were used to serve the same purpose as the factory bead-stop. __________________ DON'T RECALL DOING SOMETHING FOR MYSELF BASED ON SOMEONE ELSE'S LIKES OR DISLIKES Last edited by 51 MERC-CT; 02-05-2020 at 01:20 PM.