The Ford Barn - View Single Post

glennsanders · 01-05-2020, 09:24 PM

Thanks for all the input. I know if I had a shop back in the old days I would definitely have one. I have already put a 378 set of gears in a new rear. Going to use the stand to set up drive shaft and torque tube, radius rods , brakes. When I slide the new when under I'm ready to roll. Just my thought. I like KR Wilson tools I think they're pretty neat and then I have the option to pick this up so I did. Did I need it no .but I was excited to have a chance to buy it and put it back in working order.

01-05-2020, 09:24 PM	#19
glennsanders Senior Member Join Date: Jul 2014 Location: Sharpsburg md Posts: 480	Re: KR Wilson axle stand specs questions Thanks for all the input. I know if I had a shop back in the old days I would definitely have one. I have already put a 378 set of gears in a new rear. Going to use the stand to set up drive shaft and torque tube, radius rods , brakes. When I slide the new when under I'm ready to roll. Just my thought. I like KR Wilson tools I think they're pretty neat and then I have the option to pick this up so I did. Did I need it no .but I was excited to have a chance to buy it and put it back in working order.