Quote:
Originally Posted by Dodge
You should be able to make your weber manifold fit with a little machining. Yes you can
open up the holes that go over the studs, then you can use an end mill for nut clearance
if the manifold is thick enough, mine is. I'll look at it on my Yapp head and see what it takes. For clearance I have used Chevy/Small block Ford adjustable roller rocker arm adjusting nuts as they are round at the bottom and a 5/8 hex at the top and are over an inch tall. They may fit without machining the manifold.
|
My manifold is one of the early ones made in CA over a decade ago. It has larger tubes with thin walls so milling would open a hole in the tube.