[Tinbasher]

I looked for pictures but I don't have any for the stops. The rumble seat stops need the rubber stop block. That is installed on the end of the bracket on the 45 deg. angle part. They where riveted originally. Most guys bolt them with 10/32 machine screws. two on each rubber. The brkt. itself sits on the rear seat rizer against the rear edge. If you look underneath the seat rizer you'll see two support brkts. welded in place. The bolts go through these reinforcements. So the brkt. sits on the rear edge, with two bolts on the top edge and two bolts on the rear edge of the rizer. So the angle of the brkt. fits the rear angle of the seat rizer. It doesn't sit on the top. It's half and half on the seat rizer. I hope this helps. It's also easier to fit the rumble lid if all of your hardware is original. Which yours appear to be. Good luck JP