The Ford Barn - View Single Post

Kohnke Rebabbitting · 12-20-2018, 01:52 AM

If he sets up at .005, or .006., any thing after .006 is wore out, and that is using a crank, with old bearings.

It doesn't make any difference if it is insert thrust, or babbitt thrust.

New bearing thrust on either should not be under .003, and not over .004.

Herm.

12-20-2018, 01:52 AM	#5
Kohnke Rebabbitting Senior Member Join Date: May 2010 Location: 60615,330th Ave.,Clare, Iowa, 50524 Posts: 1,457	Re: Crankshaft End Play on Rebuild If he sets up at .005, or .006., any thing after .006 is wore out, and that is using a crank, with old bearings. It doesn't make any difference if it is insert thrust, or babbitt thrust. New bearing thrust on either should not be under .003, and not over .004. Herm.