[Benson]

If you use tubes in powder coated wheels check out this!:



Quote:
Originally Posted by Bruce View Post
Our powder coater puts a wire all the way around the rim and hangs it from a loop in the middle. The finished product has a wavy line in the drop center where the tire flap snaps in. You'll never see the wire mark when the tire is mounted.


Benson's reply:


This is same as my wheels were done ...

One word of caution ... in case you use tubes and do not use a "tire flap" :

On three of the 5 wheels I had done there was a very sharp piece of Powder coat left where they removed the wire ... Sharp enough to cut an inner tube.

Since this is inside the wheel / tire I just chiseled off the sharp edges and painted the bare metal with paint. Just in case some water gets inside the tire!