The Ford Barn - View Single Post

Jim Brierley · 05-19-2018, 11:21 AM

With a pin half way into your pistons and half into a stock piston, compare distances to the top of the piston, not the bottom as pictured. I believe the stock height is 1.906". If my measurement is right, your pistons are for a stroker crank. Double check everything. Cutting the rods as I mentioned will not affect rod strength as there is nothing out there connected to the beam section.

05-19-2018, 11:21 AM	#20
Jim Brierley Senior Member Join Date: Jun 2010 Location: Temecula, CA Posts: 4,114	Re: B Rod spec.. With a pin half way into your pistons and half into a stock piston, compare distances to the top of the piston, not the bottom as pictured. I believe the stock height is 1.906". If my measurement is right, your pistons are for a stroker crank. Double check everything. Cutting the rods as I mentioned will not affect rod strength as there is nothing out there connected to the beam section.