The Ford Barn - View Single Post

Tinker · 03-03-2018, 09:31 PM

No experience with the center dump headers.

Fentons (newer versions) on the drivers side usually need to either be milled a bit or a little grinding on the center output to get some space around stock steering box. Also have to remove them anytime you pull the engine.

Not sure about Reds availability or fit. But I have not heard anything negative about them.

03-03-2018, 09:31 PM	#3
Tinker Senior Member Join Date: May 2010 Location: MN Posts: 7,063	Re: 1938 Ford Pickup Exhaust Manifolds No experience with the center dump headers. Fentons (newer versions) on the drivers side usually need to either be milled a bit or a little grinding on the center output to get some space around stock steering box. Also have to remove them anytime you pull the engine. Not sure about Reds availability or fit. But I have not heard anything negative about them.