The Ford Barn - View Single Post - How to fix a door that doesn't close tight

Dak Rat · 11-25-2017, 08:43 AM

All very good advice, but if the door doesn't fit the hole no amount of adjusting will fix the problem. I have had to grind edges on these old ford doors and re-weld the raw edge because the door was just the wrong size to get a good gap.

11-25-2017, 08:43 AM	#12
Dak Rat Senior Member Join Date: May 2010 Location: Minot, ND Posts: 218	Re: How to fix a door that doesn't close tight All very good advice, but if the door doesn't fit the hole no amount of adjusting will fix the problem. I have had to grind edges on these old ford doors and re-weld the raw edge because the door was just the wrong size to get a good gap.