The Ford Barn - View Single Post

weemark · 07-17-2017, 01:50 AM

mike that's not so good to hear about your issues. ive never seen that crud on a water pump like that before. I wouldn't think the casting sand is your issue, I would say it was the crud on the water pumps which ha caused them to move/pump only a small amount of water. sand has been there now for 81 years and never caused any issues previously, now you know about it, its best to get it out though. I would think you will need to get the block out and spend a bit of time with a screwdriver loosening it as you wash it out.

07-17-2017, 01:50 AM	#79
weemark Senior Member Join Date: May 2010 Location: uk Posts: 367	Re: Overheating and fed up.... mike that's not so good to hear about your issues. ive never seen that crud on a water pump like that before. I wouldn't think the casting sand is your issue, I would say it was the crud on the water pumps which ha caused them to move/pump only a small amount of water. sand has been there now for 81 years and never caused any issues previously, now you know about it, its best to get it out though. I would think you will need to get the block out and spend a bit of time with a screwdriver loosening it as you wash it out.