The Ford Barn - View Single Post

Towd56 · 04-05-2017, 05:02 PM

Followed HERM's advice and was able to get it within .001 at top and both sides. The bottom is still out about .020. But I believe tranny will pull that in.

One note I wanted to mention - I would have sworn the housing was in nice shape and not cracked. I had bead blasted it clean as a whistle and couldn't see a crack. When I had it magna fluxed- 3 cracks showed up. FYI - don't trust your eyes!!!

04-05-2017, 05:02 PM	#12
Towd56 Member Join Date: Apr 2014 Location: Worcester, MA Posts: 50	Re: Flywheel housing question-Update Followed HERM's advice and was able to get it within .001 at top and both sides. The bottom is still out about .020. But I believe tranny will pull that in. One note I wanted to mention - I would have sworn the housing was in nice shape and not cracked. I had bead blasted it clean as a whistle and couldn't see a crack. When I had it magna fluxed- 3 cracks showed up. FYI - don't trust your eyes!!!