Re: Flywheel housing question
There are usually several ways to milk a cow. Generally there is the right way, wrong way and then my way.
Just another way for this problem. Mine was .032" out. I juggled shims for hours to no avail, or, not much avail. So, being too cheap or too lazy to find another housing,figuring things couldn't get any worse I went after it with a file and got it to about .010"
Then there is the pressure plate. I just turn a piece of round stock to the height you want [ .625"] and set the finger height to a slight drag on the round stock.
If the clutch disk is good along with the flywheel face then the clutch will now work nicely with no chatter.
|