|
Senior Member
Join Date: May 2010
Location: 60615,330th Ave.,Clare, Iowa, 50524
Posts: 1,457
|
Re: Flywheel housing question
Quote:
Originally Posted by Towd56
I've read just about every post regarding how to align the housing . I know you should have no more than .006 between the 12, 3, and 9 o'clock positions.
Here is my million dollar question:
Once you bolt the housing to the trans- aren't all these tolerances going to change? Won't bolting the housing to the tranny "straighten" any variance you have?
I'm currently about .025 out between the three positions. I'm trying to wrap my head around this before I go cutting the housing.
|
Putting on a Flywheel housing is easy if you do it in the right order There are other posts on here where I lay them out. to much typing all over again.
Or call me anytime at 515-546-4551.
Herm.
|