The Ford Barn - View Single Post

larry harding · 03-18-2017, 02:58 PM

i'm finally ready to install the windshield in my 31 ccpu and have a few questions;
1. there is a rubber seal with a 1/2" +- flange and then a weird shaped edge to it. i know this seal is supposed to go between the header and the windshield hinge, but exactly does it fit? where does the wierd edge go?
2.can you mount the hinge piece and slide the windshield into it, or must it all go up as one piece?
3. i am assuming this is best a two man job? i don't think the 100lb boss lady is going to be much help on this. i'll probably need to wait till some volunteers come by.

03-18-2017, 02:58 PM	#1
larry harding Senior Member Join Date: Sep 2015 Location: western n.c. Posts: 437	ccpu windshield installation i'm finally ready to install the windshield in my 31 ccpu and have a few questions; 1. there is a rubber seal with a 1/2" +- flange and then a weird shaped edge to it. i know this seal is supposed to go between the header and the windshield hinge, but exactly does it fit? where does the wierd edge go? 2.can you mount the hinge piece and slide the windshield into it, or must it all go up as one piece? 3. i am assuming this is best a two man job? i don't think the 100lb boss lady is going to be much help on this. i'll probably need to wait till some volunteers come by.