Thread: Good bye
View Single Post
Old 01-12-2017, 10:11 PM   #4
BRENT in 10-uh-C
Senior Member
 
BRENT in 10-uh-C's Avatar
 
Join Date: May 2010
Location: Eastern Tennessee
Posts: 11,971
Default Re: Good bye

Quote:
Originally Posted by tbirdtbird View Post
Yikes!

I must have missed something

as far as "self-aggrandizing morons who consider themselves not to be bound by the norms of civil society"

there are too many of them out there

I don't see it as much on the other forums I am on

Enjoy your car
Well now, hang on just a minute. The two most recent instances are one thread where someone was giving praises to Steve Becker, and several followed only to have Ian rudely hijack taking the praise away from Steve and placing it towards another vendor. Another FB regular called him out on it. I know I kinda felt uncomfortable when I read what Ian posted, however I did not say anything. I suspect others shared the same sentiment.

Another situation came up today when someone spoke of rebuilding a cross shaft and wanted to know the measurement the shaft needed to built up to. Immediately someone posted to use split bushing to which I and several others explaned why these were inferior to the original design. This countered what Ian's opinion was, so apparently he had to come forth and defend his opinion. Because folks have stated their opinions that apparently he does not agree with, we are now called Morons, and he feels the need to go participate elsewhere.

I too hate it for Ian, but surely he knows what is best for him, and if he feels he needs to go somewhere else to participate, who are we to argue with him?
__________________
.

BRENT in 10-uh-C
.
www.model-a-ford.com
...(...Finally Updated!! )

.
BRENT in 10-uh-C is offline