Quote:
Originally Posted by bwaii64
I know there's a lot on this around but I'd like to verify before I do something (else) stupid. We've got an early A with cast bearings. The end play is .025". The thrust part of the bearing looks good though we didn't totally remove the bearings. (I don't want to mess more than I have to.)
So... do I
1) leave it
2) break/grind off the rear thrust part of the bearing and put in the brass seal holder with thrust.
If 2, I'm concerned about the thickness of the thrust part. Our cast babbit thrust is about 5/32 and I'm concerned the new brass one won't be any thicker. Anyone know the measurement of that part?
Thanks
Byron
|
With that much end play it is going to leak a lot of oil. Do you have the engine out? If it was mine I would fix it.