[Capt Kirk]

1) Are there any torque numbers for the axle housings, backing plates and torque tube?

2) I greased the wheel bearings but how's a person supposed to know how many grease gun pumps is required to fill the space between the axle seal and hub seal? Do I pump it up without the hub on till it starts showing at the end of the axle housing then add more after the hub is on.

3) How many pumps for the center and end driveline bearings?

4) I haven't searched here yet but I may have questions on adjusting the brakes. The eccentrics at the bottom and the cams at the top...I'm sure there's a way I could screw it up if I didn't research.