[Charlie ny]

Dave,
Brian's offer is outstanding and I'm sure together you will both sort it.
If by any chance any of your mates has a donor 94 with a pair of the inverted 'V' nozzle bar assemblies with holding straps grab them pronto. The 'N' nozzle bar must
be fitted with just the right style idle tube....some are vented some are not. To further frustrate things the 'N' bars come in no vent single vent and multiple vent
designs. Everything must match including the 94 these bars are installed in, if they
do not match the issues you are facing will occur.
The 'V' nozzle bars seem to be happy in most every application.
If you and Brian choose to go this way ,during sorting, be sure to carefully
install the 'V' bars with 2 gaskets under each leg and careful see that the bars sit nice and proper on their seats. With both bars and straps in place snug up the rear strap and
attempt to rock the bars, they should be secure and solid feeling at this point. If
good here back the rear strap securing screws off 1/2 turn and repeat this proceedure on the front strap. At this point the squirter should also be firm and
not wiggle.
I remember to always disassemble the bars and run a tag wire thru the idle
tubes and be sure all openings in the bars are clear.
The above is only my opinion and I certainly respect all other opinions.
Charlie ny