The Ford Barn - View Single Post

Clem Clement · 07-03-2016, 09:57 PM

No good.
I dug out a couple of Alemite grease guns I had. I got a little grease in one fitting and that emptied the gun. I used a screwdriver to fill and burp the gun. Then tried the center shaft. No good enough. (I'm using grease I pullout of a refill tube.
I have forgotten how to burp a grease gun.

07-03-2016, 09:57 PM	#14
Clem Clement Senior Member Join Date: May 2010 Location: Fairfax, VA Posts: 3,532	Re: Greasing spindles No good. I dug out a couple of Alemite grease guns I had. I got a little grease in one fitting and that emptied the gun. I used a screwdriver to fill and burp the gun. Then tried the center shaft. No good enough. (I'm using grease I pullout of a refill tube. I have forgotten how to burp a grease gun.