The Ford Barn - View Single Post

Bruce Lancaster · 07-01-2016, 10:00 AM

I think my imperatives would mostly involve maybe a cast-in porting job, maybe extra metal and/or deeper water jacket in crack zone (after study of the 1946 press release on that area!), mebbe make the block webs thick slabs like the do on aftermarket SBC's. Everything generally works on flatheads, it would just be nice to have easy clean ones!
Radical changes? Seems silly. Chevy successfully updated the flathead in 1955 with the obvious modernizations, and those easily fit where a flathead lived if someone wants lots more steam.
Oh yes...some good stock looking iron heads done like Denvers, with tightened up chamber volume and decent transfer area! That would be a neat starting point and fundraiser for a block project...

07-01-2016, 10:00 AM	#11
Bruce Lancaster Member Emeritus Join Date: May 2010 Location: Madison, NJ Posts: 5,230	Re: New block, a further discussion I think my imperatives would mostly involve maybe a cast-in porting job, maybe extra metal and/or deeper water jacket in crack zone (after study of the 1946 press release on that area!), mebbe make the block webs thick slabs like the do on aftermarket SBC's. Everything generally works on flatheads, it would just be nice to have easy clean ones! Radical changes? Seems silly. Chevy successfully updated the flathead in 1955 with the obvious modernizations, and those easily fit where a flathead lived if someone wants lots more steam. Oh yes...some good stock looking iron heads done like Denvers, with tightened up chamber volume and decent transfer area! That would be a neat starting point and fundraiser for a block project...