Quote:
Originally Posted by aonemarine
I could see myself spending $2500.00 on a new fully machined block but not much more.
There is just too many good used blocks still available to warrant spending much more. Basically there just is not enough demand to make casting a new "replacement" block a fruitful venture.
|
Considering that with the Flathead Ford you're getting the cylinder cases AND the porting and valvetrain area with the block itself I think $2500- $3000 would appeal to a lot of people. Maybe more than we think.
Do you suppose a block such as the one we are talking about could spawn the era of the $6500 Flathead crate engine that can entertain you with 200-225 hp and 275- 300 ft/lbs of torque?