The Ford Barn - View Single Post

Fordors · 06-26-2016, 04:46 PM

I think the video shows why the project was aborted. In addition to Mark Kirby there was an additional brain trust involved in the project and they re-engineered the whole package. There isn't much they left on the table that is not unique to the MCFH aluminum block; d-ports, smaller, relocated head studs, roller cam and unique guides, proprietary heads needed for new stud locations, revised oil pan, water pumps, front cover, cam gears, Fluiddamper balancer and on and on.
It is for certain a complete work of engineering excellence, but all the upgrades made it out of reach ($$$$$) for the typical hobbiest and it's for that reason I think the project was shelved. Who wouldn't want one, but how many could pay for, or justify the cost?

06-26-2016, 04:46 PM	#10
Fordors Senior Member Join Date: May 2010 Location: Orland Park,IL Posts: 1,408	Re: Could Edelbrock cast a flathead block I think the video shows why the project was aborted. In addition to Mark Kirby there was an additional brain trust involved in the project and they re-engineered the whole package. There isn't much they left on the table that is not unique to the MCFH aluminum block; d-ports, smaller, relocated head studs, roller cam and unique guides, proprietary heads needed for new stud locations, revised oil pan, water pumps, front cover, cam gears, Fluiddamper balancer and on and on. It is for certain a complete work of engineering excellence, but all the upgrades made it out of reach ($$$$$) for the typical hobbiest and it's for that reason I think the project was shelved. Who wouldn't want one, but how many could pay for, or justify the cost? __________________ My school colors are black and blue, I attended the School of Hard Knocks where I received a Masters Degree in Chronic Mopery.