The Ford Barn - View Single Post

Henry Floored · 06-26-2016, 12:33 PM

BTW, as I mentioned earlier. To have an international funds drive to fund this venture would be far more possible than trying to find a few guys willing to put up thousands while the rest of the Ford V8 world watches in anticipation.

Does anyone know how many members the EF V8 club counts world wide?

If such a project would cost say $500,000 US dollars and there were 5000 members of the EF V8 club willing to put up $100 I think that would about cover it don't you?

The original "investors" of course would be reimbursed on the purchase of their own new block.

Tell me again, why can't we do this guys?

06-26-2016, 12:33 PM	#20
Henry Floored Senior Member Join Date: May 2010 Location: Florida Posts: 611	Re: Could Edelbrock cast a flathead block BTW, as I mentioned earlier. To have an international funds drive to fund this venture would be far more possible than trying to find a few guys willing to put up thousands while the rest of the Ford V8 world watches in anticipation. Does anyone know how many members the EF V8 club counts world wide? If such a project would cost say $500,000 US dollars and there were 5000 members of the EF V8 club willing to put up $100 I think that would about cover it don't you? The original "investors" of course would be reimbursed on the purchase of their own new block. Tell me again, why can't we do this guys?