The Ford Barn - View Single Post

Ol' Ron · 06-22-2016, 10:38 AM

I've often thought of this, and I really don't think it would be much trouble. There are very accurate blueprints of the block. You could even upgrade some of the weak areas. Using computer generated tooling and CNC machining, I'm sure that you could have a much better block made form a better material. I would have Caterpillar do the casting as they have a modern foundry and do allot of NASCAR work. Now if you had a large quantity done you could bring the cost down to a very reasonable price, say 5 to 8 grand apiece.

06-22-2016, 10:38 AM	#1
Ol' Ron Senior Member Join Date: May 2010 Location: Chester Vt Posts: 8,985	Re: Could Edelbrock cast a flathead block I've often thought of this, and I really don't think it would be much trouble. There are very accurate blueprints of the block. You could even upgrade some of the weak areas. Using computer generated tooling and CNC machining, I'm sure that you could have a much better block made form a better material. I would have Caterpillar do the casting as they have a modern foundry and do allot of NASCAR work. Now if you had a large quantity done you could bring the cost down to a very reasonable price, say 5 to 8 grand apiece.