The Ford Barn - View Single Post

rockfla · 06-22-2016, 09:53 AM

With the 3D printers of today and watching how easy it is to make the molds and then make sand castings of them I think it would be fairly EASY to recast flat head blocks. NOW from the financial feasibility aspect I don't know if the cost/profit is or would be worth it. Watching Ferrari cast their block on the lastest "How it's made" (I know its in condensed form) but still very easy and quick process.

06-22-2016, 09:53 AM	#3
rockfla Senior Member Join Date: Mar 2014 Location: Jacksonville FL Posts: 4,803	Re: Could Edelbrock cast a flathead block With the 3D printers of today and watching how easy it is to make the molds and then make sand castings of them I think it would be fairly EASY to recast flat head blocks. NOW from the financial feasibility aspect I don't know if the cost/profit is or would be worth it. Watching Ferrari cast their block on the lastest "How it's made" (I know its in condensed form) but still very easy and quick process.