The Ford Barn - View Single Post

Lawson Cox · 06-18-2016, 11:23 AM

I am thinking of lowering the cab a tad on my pickup to get the belt molding on the cab to align with the belt molding on the hood. Can't do it very easy by trying to align radiator end. Too much out of line to just adjust hood itself.

I think I can loosen cab bolts and jack cab up enough to remove long wooden supports and trim them a little to make it right. HAS ANYONE DONE THIS? AM I DREAMING???

Any suggestions or comments welcome.

Thanks in advance.

06-18-2016, 11:23 AM	#1
Lawson Cox Senior Member Join Date: May 2010 Location: Above the gnat line in Georgia Posts: 7,079	Lifting cab on 35 PU I am thinking of lowering the cab a tad on my pickup to get the belt molding on the cab to align with the belt molding on the hood. Can't do it very easy by trying to align radiator end. Too much out of line to just adjust hood itself. I think I can loosen cab bolts and jack cab up enough to remove long wooden supports and trim them a little to make it right. HAS ANYONE DONE THIS? AM I DREAMING??? Any suggestions or comments welcome. Thanks in advance. __________________ Life is like a roll of toilet paper. The closer to the end, the faster it goes. It is better to be seen, than viewed. "We sleep safe in our beds because rough men stand ready in the night to visit violence on those who would do us harm".