The Ford Barn - View Single Post

35ragtop · 06-11-2016, 04:04 PM

Have been playing off and on with my 34 rear assembly for several weeks now. I have done a lot of searching and reading on here and the HAMB about various installation combinations, and one thing I do recall was that in some cases the back of the ring gear needs to be relieved (with an angle grinder) to clear the early axle housings. This may be the case with your installation. Try this and see.
regards
Dave

06-11-2016, 04:04 PM	#2
35ragtop Senior Member Join Date: Dec 2010 Location: Gold Coast , Australia Posts: 250	Re: '34 ring/pinion (3.54 set) issues? Have been playing off and on with my 34 rear assembly for several weeks now. I have done a lot of searching and reading on here and the HAMB about various installation combinations, and one thing I do recall was that in some cases the back of the ring gear needs to be relieved (with an angle grinder) to clear the early axle housings. This may be the case with your installation. Try this and see. regards Dave