The Ford Barn - View Single Post

Tom Wesenberg · 05-15-2016, 07:18 AM

If I lived closer to the Henry Ford Museum I'd be over at the Benson Ford Research Center looking at the GAV blueprint.

At any rate, the 7/16" deep socket is a common part, so all we need are a bunch of 13/32" quality sockets.

I filed out a 10 mm Snap On 6 point box wrench about 10 years ago, and that works fine, but a 6 point socket would be even better.

05-15-2016, 07:18 AM	#328
Tom Wesenberg Senior Member Join Date: May 2010 Location: Mpls, MN Posts: 27,582	Re: carburetor 13/32 deep well socket If I lived closer to the Henry Ford Museum I'd be over at the Benson Ford Research Center looking at the GAV blueprint. At any rate, the 7/16" deep socket is a common part, so all we need are a bunch of 13/32" quality sockets. I filed out a 10 mm Snap On 6 point box wrench about 10 years ago, and that works fine, but a 6 point socket would be even better.