02-18-2016, 03:00 PM
|
#3
|
Senior Member
Join Date: Jul 2011
Location: Redondo Beach, CA
Posts: 5,883
|
Re: How far to screw in end plug on tie rod ends
Quote:
Originally Posted by ahirt
It occurs to me that if 25% compression means 25% of the deflection height then it is easy to see that 25% of ¼ inch is 1/16 inch or .0625 inch Tightening the end plug 1 to 1.5 turns would be putting it within a range of .050 to .075 inch - or exactly in the middle of a 25% compression of the deflection height. So Les’ instructions are accurate IF 25% compression means 25% of the “compressible” length.
So what is the correct figure?? Help!!
|
I don't know the correct answer but I would go with your Option #1 (above). I don't believe that having the spring collapsed to within 1/16" of coil bind was what was originally intended. Not to mention it would be pretty tight.
|
|
|