The Ford Barn - View Single Post

Dodge · 02-07-2016, 10:01 PM

Take that numer 4 rod and use a permanent marker pin to coat all surfaces of the bearing including the sides of the bearing and see if there are any high spots after you turn it a couple of revolutions. If you see them you'll have to scrape the bearing in.

02-07-2016, 10:01 PM	#5
Dodge Senior Member Join Date: Nov 2011 Location: Sonoma, CA. Posts: 1,568	Re: Engine Frustration Take that numer 4 rod and use a permanent marker pin to coat all surfaces of the bearing including the sides of the bearing and see if there are any high spots after you turn it a couple of revolutions. If you see them you'll have to scrape the bearing in.