The Ford Barn - View Single Post

Big hammer · 12-27-2015, 08:50 PM

I made a tow bar that attached to the axle near the spring ends. With out body on, going
forward was good, backing up no way. Turning a corner I could watch the steering wheel
turning. After installing body it would not track, I had to lubricate the front end. It was
good to go after that.

12-27-2015, 08:50 PM	#11
Big hammer Senior Member Join Date: Jun 2014 Location: Land of Lincoln Posts: 3,430	Re: My tow bar bracket setup on bumper I made a tow bar that attached to the axle near the spring ends. With out body on, going forward was good, backing up no way. Turning a corner I could watch the steering wheel turning. After installing body it would not track, I had to lubricate the front end. It was good to go after that.