The Ford Barn - View Single Post - Neoprene Gas Float Too Long, Hole Too Wide

w.michael · 11-07-2015, 05:20 PM

Yes, you can cut a notch in the "neoprene" float as suggested. It cuts easily with a utility knife. Then the float will slip onto the "L" of the wire and the long side of the "L" will fit into the notch. That gives you enough wire sticking out of the float to solder or epoxy or JB Weld the washer onto the wire.

W. Michael

11-07-2015, 05:20 PM	#5
w.michael Senior Member Join Date: May 2010 Location: North Carolina Posts: 445	Re: Neoprene Gas Float Too Long, Hole Too Wide Yes, you can cut a notch in the "neoprene" float as suggested. It cuts easily with a utility knife. Then the float will slip onto the "L" of the wire and the long side of the "L" will fit into the notch. That gives you enough wire sticking out of the float to solder or epoxy or JB Weld the washer onto the wire. W. Michael