The Ford Barn - View Single Post - Neoprene Gas Float Too Long, Hole Too Wide

ericr · 11-07-2015, 04:41 PM

the float extends flush with the arm of the gas gauge, no way to install the tiny brass washer, assuming one could remove and recreate the little flat in the rod. The float won't stay on by compression, hole too wide.

does neoprene melt under a propane torch flame?

11-07-2015, 04:41 PM	#1
ericr Senior Member Join Date: Apr 2012 Posts: 1,542	Neoprene Gas Float Too Long, Hole Too Wide the float extends flush with the arm of the gas gauge, no way to install the tiny brass washer, assuming one could remove and recreate the little flat in the rod. The float won't stay on by compression, hole too wide. does neoprene melt under a propane torch flame?