The Ford Barn - View Single Post

BRENT in 10-uh-C · 05-20-2015, 10:59 AM

Wish I knew you were looking for one as I purchased two at Hershey last Fall and then had them correctly plated. I will use one for a current project and so I have one of the non-clipped and one of the clipped, --both that are the early non-countersunk screw holes.

05-20-2015, 10:59 AM	#2
BRENT in 10-uh-C Senior Member Join Date: May 2010 Location: Eastern Tennessee Posts: 11,971	Re: Very rare early 28 dash Wish I knew you were looking for one as I purchased two at Hershey last Fall and then had them correctly plated. I will use one for a current project and so I have one of the non-clipped and one of the clipped, --both that are the early non-countersunk screw holes. __________________ . BRENT in 10-uh-C . www.model-a-ford.com ...(...Finally Updated!! ) .