The Ford Barn - View Single Post

mrtexas · 05-20-2015, 07:34 AM

Here are a few shots of the AR dash I just bought:

No indentation for bottom screw holes, cut rather than pressed

Bottom screw holes 1/4 wider apart

No cut off on top

I've compared it with an original later dash. I'll have some work to do! I had modified my gas tank to fit a later dash. No one here could answer my question if the bottom screw holes were wider apart! Thanks to Gary Nelson of BC(British Columbia) and Fordbarn for selling me several AR parts this included and early Canadian motor mounts. http://fordbarn.com/forum/showthread...light=canadian

05-20-2015, 07:34 AM	#1
mrtexas Senior Member Join Date: May 2010 Location: Sugar Land, TX Posts: 4,420	Very rare early 28 dash Here are a few shots of the AR dash I just bought: No indentation for bottom screw holes, cut rather than pressed Bottom screw holes 1/4 wider apart No cut off on top I've compared it with an original later dash. I'll have some work to do! I had modified my gas tank to fit a later dash. No one here could answer my question if the bottom screw holes were wider apart! Thanks to Gary Nelson of BC(British Columbia) and Fordbarn for selling me several AR parts this included and early Canadian motor mounts. http://fordbarn.com/forum/showthread...light=canadian Last edited by mrtexas; 05-20-2015 at 07:42 AM.