[Patrick L.]

Originally Posted by 31 Model A

I took the rumble out, and to leave it out and use it as a trunk, second to fix the handle lock since it had no key. When I took it out, the previous owner did not use the D nuts and screws to secure the bottom part of the backrest. It was two wood screws and a washers drill into the lid frame. No problem, I was leaving the seat out anyway. Took the handle off and took it to a locksmith where he cut a new key to fit the original tumblers. Picked it up today, worked fine until I went to lock the lid down. The latch coming out of the cylinder is not slotting itself when I go to lock it. The slotted circle inside the lid is too far away for the latch to fit down inside. OK, so the rumble can't be locked, so I decided to put the rumble back................sure!!!! Back went in OK but getting it bolted down at that angle by someone not so agile anymore is another thing. I did order and get the proper D bolts but finding the hole at my age, is a different matter.......to make a story even longer, the rumble is back in, secured, seat in place and secured and the handle is back as it was.......................

I was fighting cramps both in my fingers and brain when I posted this thread, sorry for the confusion. It was meant to relieve myself of impure thoughts.

Ahhh, makes sense now. I understand, I get brain cramps myself.