The Ford Barn - View Single Post

Ed Northrop · 03-10-2015, 07:08 PM

I took a big block Mopar to the machine shop along with a set of 30 over TRW forged pistons they refused to use pistons spec as they said the clearance was to tight. They allowed .008 for clearance or they would not do the work. I have to say they must have been right as there is no piston slap.

03-10-2015, 07:08 PM	#19
Ed Northrop Senior Member Join Date: May 2010 Location: Naples, New York Posts: 182	Re: Tight Piston Clearance, Not Model A I took a big block Mopar to the machine shop along with a set of 30 over TRW forged pistons they refused to use pistons spec as they said the clearance was to tight. They allowed .008 for clearance or they would not do the work. I have to say they must have been right as there is no piston slap.