The Ford Barn - View Single Post

George Miller · 12-25-2014, 02:48 PM

Chris I for one want to thank you for your work with the crank. Our hobbly needed good cranks. The last crank that I installed was a SCAT. I like the idea of 4340, but was disappointed with all the square edges from journal to journal. Seems to me that it would have a lot of resistance going through the air and oil Also around the rod journal was different than any thing that I have seen.

So for me I'm going to give your crank the highest marks.

12-25-2014, 02:48 PM	#48
George Miller Senior Member Join Date: May 2010 Location: NC Posts: 2,975	Re: burlington crank Chris I for one want to thank you for your work with the crank. Our hobbly needed good cranks. The last crank that I installed was a SCAT. I like the idea of 4340, but was disappointed with all the square edges from journal to journal. Seems to me that it would have a lot of resistance going through the air and oil Also around the rod journal was different than any thing that I have seen. So for me I'm going to give your crank the highest marks.