The Ford Barn - View Single Post

Richard Lorenz · 12-20-2014, 10:42 PM

Some years ago the reamers sold for this job were too large. It was only about 0.002 inches too large, but that is too much. That is why so many are recommending honing.

12-20-2014, 10:42 PM	#20
Richard Lorenz Senior Member Join Date: May 2010 Posts: 447	Re: King Pin Reamer Needed Some years ago the reamers sold for this job were too large. It was only about 0.002 inches too large, but that is too much. That is why so many are recommending honing.