Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 18 of 18
Search took 0.00 seconds.
Search: Posts Made By: acereske
Forum: Early V8 (1932-53) 06-14-2020, 06:56 PM
Replies: 8
Views: 721
Posted By acereske
Re: Rear seat small vent windows

Thanks TJ, I'll give them a try
Forum: Early V8 (1932-53) 06-13-2020, 02:22 PM
Replies: 8
Views: 721
Posted By acereske
Re: Rear seat small vent windows

Thanks Terry and Don, I pthink that I have two driver's side levers. I'll probably just check around and try to find a passenger side one. Any suggestions where I might check? Thanks again Terry and...
Forum: Early V8 (1932-53) 06-12-2020, 03:57 PM
Replies: 8
Views: 721
Posted By acereske
Re: Rear seat small vent windows

Come on guys and gals, I can't believe that no one has the answer and all are stumped or was it so obvious that I should know the answer and don't! Somebody out there must know. Thanks, I think!!!
Al
Forum: Early V8 (1932-53) 06-09-2020, 09:43 AM
Replies: 8
Views: 721
Posted By acereske
Rear seat small vent windows

My 36 Ford fordor sedan humpback has two small vent windows in the rear seat area that have flip levers that lock them. The driver's side is locked when flipped down and the passenger's side is...
Forum: Early V8 (1932-53) 05-21-2020, 11:52 AM
Replies: 6
Views: 701
Posted By acereske
36 Ford Sedan headlight bezel removal

My headlight lens is slightly loose and I purchased grommets to firm them up. After loosening the clamp on the bottom of the bezel I tried to remove the bezel. No luck as I didn't want to force it...
Forum: Early V8 (1932-53) 04-22-2020, 09:05 AM
Replies: 8
Views: 737
Posted By acereske
Re: Early fluid temp gauge repair

swanwaco32 - you're spot on with John Wolf in OH. They can rebuild originals of yours about $190 or theirs about $260. Excellent craftsmanship. Very happy with mine. The one I had, had lost color but...
Forum: Early V8 (1932-53) 03-28-2020, 10:18 AM
Replies: 29
Views: 2,308
Posted By acereske
Battery purchase & best shut off location

36 Ford fordor sedan humpback - 6 volt positive ground - I don't get to drive it regularly and it is stored where there is no electricity. I need a battery replacement but have not been able to find...
Forum: Early V8 (1932-53) 03-20-2020, 05:50 PM
Replies: 6
Views: 433
Posted By acereske
Re: 36 Ford fordor sedan dash gauges removal

Thanks to all for your much appreciated information. The task at hand now appears to be doable. Al
Forum: Early V8 (1932-53) 03-20-2020, 11:24 AM
Replies: 6
Views: 433
Posted By acereske
Forum: Early V8 (1932-53) 03-20-2020, 11:03 AM
Replies: 6
Views: 433
Posted By acereske
36 Ford fordor sedan dash gauges removal

I need to remove my amp meter/temp gauge cluster to replace. Do I need to remove the dash? If so, how? Thanks for any suggestions!
Forum: Early V8 (1932-53) 03-17-2020, 12:49 PM
Replies: 13
Views: 961
Posted By acereske
Re: clips needes

35fordtn - I looked on your eBay store but couldn't locate the part. I am a frequent buyer of store. Could you contact me direct?
Forum: Early V8 (1932-53) 03-17-2020, 11:42 AM
Replies: 13
Views: 961
Posted By acereske
Re: clips needes

3 would be fine
Forum: Early V8 (1932-53) 03-16-2020, 01:01 PM
Replies: 13
Views: 961
Posted By acereske
clips needes

Clip needs for 1936 Ford Fordor Humpback Sedan stock. I'm looking for the clips that hold the capillary wire from the water temp sending unit to the temp gauge. They hold the capillary wire to the...
Forum: Early V8 (1932-53) 03-12-2020, 01:55 PM
Replies: 8
Views: 1,049
Posted By acereske
Re: New alternator install

Thanks for the information. You mentioned 1 wire hook up. To where and does it have to be a thicker wire like the other wiring throughout the chassis?
Forum: Early V8 (1932-53) 03-11-2020, 05:33 PM
Replies: 8
Views: 1,049
Posted By acereske
New alternator install

I have a 1936 Ford Fordor sedan humpback with original V8 and 6 volt generator with positive ground. I am considering installing a positive ground 6 volt alternator to improve electrical for lighting...
Forum: Early V8 (1932-53) 02-18-2020, 06:21 PM
Replies: 1
Views: 417
Posted By acereske
Re: Placement of air cleaner decals

Per the Early Ford V-8 Club's book "1935-1936 Ford". A decal was located on the right (passenger) side of the air filter when it was oriented with the "FRONT" embossment facing front, and the vent...
Forum: Early V8 (1932-53) 01-15-2020, 04:29 PM
Replies: 2
Views: 439
Posted By acereske
Forum: Early V8 (1932-53) 01-15-2020, 03:48 PM
Replies: 2
Views: 439
Posted By acereske
Temp gage 36 Ford

Car is new to me and the temp gage doesn't seem to be working. Clear fluid in the bottom of the gage and it doesn't rise at all when engine is warm. Can the unit be rebuilt and if so by whom?
Showing results 1 to 18 of 18

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 11:49 AM.