Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 129
Search took 0.01 seconds.
Search: Posts Made By: Ingram 33vicky
Forum: Early V8 (1932-53) 05-10-2018, 12:12 AM
Replies: 15
Views: 2,642
Posted By Ingram 33vicky
Re: seized rear hub

After trying all methods suggested and tried It finally gave it up and came off. Only after using my die grinder and six 3" discs and cutting all but the axle away from the threaded end of the axle...
Forum: Early V8 (1932-53) 05-08-2018, 12:19 PM
Replies: 15
Views: 2,642
Posted By Ingram 33vicky
Re: seized rear hub

OK have the generic puller that pulls on the inner ring of the hub. next best thing to a genie KRWislon puller.
Pull with puller -- did not work
Pull with puller and rap on center of puller --did...
Forum: Early V8 (1932-53) 05-06-2018, 08:23 PM
Replies: 15
Views: 2,642
Posted By Ingram 33vicky
Re: seized rear hub

I call the puller that grips the snout "genuine" as it is designed especially for Ford hubs.
Forum: Early V8 (1932-53) 05-06-2018, 08:00 PM
Replies: 15
Views: 2,642
Posted By Ingram 33vicky
Unhappy seized rear hub

Need to pull rear brake drum from the axle. I have put maximum torque with a genuine Ford rear axle puller, have also tried heat and puller, air impact gun with genuine puller.
My next trial will...
Forum: Early V8 (1932-53) 01-05-2018, 05:33 PM
Replies: 74
Views: 13,122
Posted By Ingram 33vicky
Re: Dearborn 2018 Grand National Meet

All set to go only need to make a decision to trailer my 46 woody or drive it. Would like to caravan with others from the West coast. Anyone else from Oregon want to make a cruise? email me or...
Forum: Early V8 10-30-2017, 06:29 PM
Replies: 0
Views: 985
Posted By Ingram 33vicky
46 Hubcap

Need a 46 hubcap in good to new or repop condition. Lost along the road somewhere. Want a match for the three Drake caps on the caar.
Call 541-990-7377 or email at [email protected]
Thanks,...
Forum: Early V8 (1932-53) 10-27-2017, 01:07 PM
Replies: 90
Views: 20,536
Posted By Ingram 33vicky
Re: EFV8 Grand National Meet 2018

Have sent in registration. waiting for information on hotels. Am undecieded on taking my 46 woodie 6 cyl w/Columbia. Drive or trailer it? Anyone from the West setting up a tour group? Paul
Forum: Early V8 (1932-53) 09-29-2017, 12:41 PM
Replies: 5
Views: 1,063
Posted By Ingram 33vicky
Re: brake cross shaft assembly

I believe the 36 used solid "brake rods" and the 37 used cables. The Parts book indicates different prefix on the assembly in 36 and 37. I think I have a 37 in my pile of parts. email me at...
Forum: Early V8 (1932-53) 06-16-2017, 01:41 PM
Replies: 5
Views: 1,302
Posted By Ingram 33vicky
Re: 1946 6 cyinder woodie production

I have a 1946 woodie with a 6 cylinder engine. It is stamped on the firewall as a 6GA. Horn placement on passenger side, and battery box on drivers side. I have restored the car and have also...
Forum: Early V8 (1932-53) 06-15-2017, 01:36 PM
Replies: 5
Views: 1,302
Posted By Ingram 33vicky
1946 6 cyinder woodie production

Can anyone provide the number of 1946 woodie station wagons were produced. They should be stamped with 6GA on the upper firewall. Any information or source to look is appreciated. Please email me...
Forum: Early V8 (1932-53) 04-12-2017, 12:58 PM
Replies: 32
Views: 6,543
Posted By Ingram 33vicky
Re: Is an Overdrive avail for 1947 Sedan?

My 46 wagon is running a 3:78 with a Columbia. Very nice running about 60 - 65 on freeway. Major Columbia parts are available, the original controls are expensive. The mount for the controls on a...
Forum: Early V8 03-13-2017, 01:20 PM
Replies: 0
Views: 863
Posted By Ingram 33vicky
Sectioned 50 Club Cpe, Project

1950 club coupe, 4 1/2" sectioned body. All body and frame blasted and in primer. No engine or transmission. Floor and rockers replaced where needed. New rear quarters need to be welded in and...
Forum: Early V8 (1932-53) 10-28-2016, 12:32 PM
Replies: 4
Views: 1,179
Posted By Ingram 33vicky
Re: 1946 Ford running board stainless trim question.

Shoot me an email address and/or a phone number. I think they are the same, length may be different for coupe, 4-door, wagon. I have the name and phone number for a fellow in Oregon who made a set...
Forum: Early V8 (1932-53) 10-25-2016, 01:05 PM
Replies: 36
Views: 13,591
Posted By Ingram 33vicky
Re: Flat 6

Had a great time at the Western V8 meet in Bakersfield. Managed to get through the judging with only 24 points deducted. Will work those areas over and show the car at the 2017 meet in Salem...
Forum: Early V8 (1932-53) 09-29-2016, 01:37 PM
Replies: 36
Views: 13,591
Posted By Ingram 33vicky
Re: Flat 6

Misprint, I have a 1946 woodie, NOT a 36
Paul
Forum: Early V8 (1932-53) 09-29-2016, 01:36 PM
Replies: 36
Views: 13,591
Posted By Ingram 33vicky
Re: Flat 6

Have a factory rebuilt (.020-.020 rods mains and bore) G series engine in my 36 woody. Firewall stamping indicated a 6-cyl. when new so I went that route in my restoration. Runs like a top and with...
Forum: Early V8 (1932-53) 08-09-2016, 03:51 PM
Replies: 34
Views: 6,779
Posted By Ingram 33vicky
Re: Just how dumb was I?

Bought my 33 Victoria for $100 in 1953. Hot rodded it in 1954-55. Then restored in about 1960. Have had several offers to double my money, but still turned them down. Many flatheads have come and...
Forum: Early V8 (1932-53) 07-28-2016, 12:53 PM
Replies: 52
Views: 7,752
Posted By Ingram 33vicky
Re: Restoration Regrets/Learning Experiences

When you hire someone to do a job that you can not do yourself NEVER pay more than 10% in advance and NEVER make the final payment without inspecting the work. Even among friends a written agreement...
Forum: Early V8 (1932-53) 06-29-2016, 07:56 PM
Replies: 9
Views: 2,663
Posted By Ingram 33vicky
Re: Fender welting painted?

All the information I have for my 46 Woodie is the welt is painted body color.
Not sure if this was the same in 41.
Paul
Forum: Early V8 (1932-53) 06-01-2016, 12:42 PM
Replies: 18
Views: 2,931
Posted By Ingram 33vicky
Re: What are my options?

you will need the radiator, front motor mounts, front shroud and radiator brackets. The transmission case is also different (all the gears interchange). Not sure of flywheel and clutch.
The 6 is...
Forum: Early V8 05-30-2016, 03:43 PM
Replies: 0
Views: 630
Posted By Ingram 33vicky
Spark Plugs

Looking for a NOS or very Good used H-10 Champion spar plugs. Need 6.
Thanks, Paul
Please reply with email
Forum: Early V8 (1932-53) 05-22-2016, 09:57 PM
Replies: 4
Views: 1,997
Posted By Ingram 33vicky
Distributer timing fixture

Just came across what I was told is a fixture for setting the early Ford distributers.
Only thing I have to go on is the name CHEC RITE. If anyone has the instructions for this device I would...
Forum: Early V8 (1932-53) 04-30-2016, 11:48 AM
Replies: 11
Views: 1,974
Posted By Ingram 33vicky
Re: 1936 21-Stud Waterpump Heater Connection

Looks like the water pump is on the wrong side
Forum: Early V8 04-20-2016, 12:41 PM
Replies: 0
Views: 1,543
Posted By Ingram 33vicky
NOS bearings, rings

Have the following Ring sets, Main Bearings, cam and rod bearings available. All in Ford boxes.
I would prefer to sell all as one lot but will take Names and offers for individual items and will...
Forum: Early V8 (1932-53) 03-11-2016, 02:19 PM
Replies: 1
Views: 1,105
Posted By Ingram 33vicky
patch panels

Am in need of rear quarter patch panels for my 50 Ford. Not sure if I will live long enough to order from the dealer that makes the panels that everyone says are the best. Can anyone give me...
Showing results 1 to 25 of 129

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 01:50 PM.