Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 42
Search took 0.00 seconds.
Search: Posts Made By: dbaldwi3
Forum: Model A (1928-31) 11-20-2019, 07:33 AM
Replies: 11
Views: 444
Posted By dbaldwi3
Re: Remove/Replace Headlight Reflector

Open lens cover, remove bulbs, gently pull reflector bucket forwards it will slide right out.
Forum: Model A (1928-31) 11-17-2019, 02:12 PM
Replies: 18
Views: 815
Posted By dbaldwi3
Re: Remove inner oil pan

Believe it or not a Wooden baseball bat slid into the side and give it a good pop it will come out.
Forum: Model A (1928-31) 11-02-2019, 11:29 AM
Replies: 6
Views: 304
Posted By dbaldwi3
Re: Thread size - windshield frame screws?

In restoring my Tudor I’ve found Henry liked 10-24 thread size and can be purchased through restoration supply houses.
Forum: Model A (1928-31) 11-01-2019, 01:42 PM
Replies: 8
Views: 849
Posted By dbaldwi3
Re: Radial Tires 16 inch Kelsey Hayes

Here’s a chart I found with dimensions https://racedunlop.com/docs/40sand50s.pdf then go here https://www.tacomaworld.com/tirecalc?tires=195-80r16-195-75r16 and plug in a modern tire size to compare...
Forum: Model A (1928-31) 11-01-2019, 01:38 PM
Replies: 8
Views: 849
Posted By dbaldwi3
Re: Radial Tires 16 inch Kelsey Hayes

P195/80-r16 but good luck as far as I can tell only one tire that size the Bridgestone ecopia e2 made for electric rav4 in California
Forum: Model A (1928-31) 10-30-2019, 05:37 PM
Replies: 15
Views: 785
Posted By dbaldwi3
Re: Steering Wobble

Radius ball
Forum: Model A (1928-31) 10-29-2019, 07:36 PM
Replies: 15
Views: 785
Posted By dbaldwi3
Re: Steering Wobble

Did you look at front radius ball? I was told this can cause wobble.
Forum: Model A (1928-31) 10-22-2019, 06:41 PM
Replies: 20
Views: 1,852
Posted By dbaldwi3
Re: Side Mirror Installation Tips Needed

Not trying to hijack this thread but I just installed a drivers side mirror on my Tudor, after trying all recommended methods I ended up having to drill the hinge pin completely out. My problem is...
Forum: Model A (1928-31) 10-08-2019, 05:57 PM
Replies: 4
Views: 467
Posted By dbaldwi3
Re: Need help polishing a 1931 grill shell

Mine was so bad I had to start at 320, 500,1200, 3000, polishing wheel now it looks like a mirror. Have to admit I was scared hitting it with 320 though! And don’t be in a rush take your time.
Forum: Model A (1928-31) 09-19-2019, 07:20 PM
Replies: 10
Views: 441
Posted By dbaldwi3
Re: Help, Paint Application Problems

Recently had the same problem I waited till it cured then wet sanded the effected area and sprayed it again no problem the second time. Assumed it was either the tack rag or wax/grease remover
Forum: Model A (1928-31) 09-19-2019, 07:15 PM
Replies: 11
Views: 474
Posted By dbaldwi3
Re: Broken gless

Just purchased a passenger side glass for my Tudor locally for $47.00 installation was pretty easy. As a side note today I installed all the new door hardware and concluded it’s best to turn handle...
Forum: Model A (1928-31) 09-18-2019, 06:37 AM
Replies: 16
Views: 2,415
Posted By dbaldwi3
Re: Lebaron Bonney has closed????

Here’s a company I found doing a quick search they say they do model a headliners wlsheadliners.com I know nothing of their quality or authenticity.
Forum: Model A (1928-31) 08-07-2019, 04:55 PM
Replies: 2
Views: 336
Posted By dbaldwi3
Re: steering question

Just guessing but your probably at its right limit. Unless the pitman arm is keyed I would put it at the 1:30 position then remove pitman arm and reattach it at 12:00.this should give you equal...
Forum: Model A (1928-31) 08-01-2019, 05:45 PM
Replies: 64
Views: 5,917
Posted By dbaldwi3
Re: Shop lighting

Upgraded half of my garage with sunco 8 pack of 4’ led complete fixtures for 190.00 on Amazon. old fixtures had bad bulbs and or bad ballasts just threw them all out, the new ones are 4500 lumens...
Forum: Model A (1928-31) 07-04-2019, 03:51 PM
Replies: 6
Views: 664
Posted By dbaldwi3
Re: Model A Horn

Couple of guesses, is it blowing erratically when pressed? then I would look for a bad connection at the bottom of steering column specifically the light switch connector . Is it blowing erratically...
Forum: Model A (1928-31) 05-27-2019, 11:53 AM
Replies: 7
Views: 423
Posted By dbaldwi3
Re: Memorial Day

many people make the same mistake their intentions are good, However what bothers me more than anything is how it’s become another day for stores to boost sales using a day to reflect on those...
Forum: Model A (1928-31) 05-10-2019, 05:29 PM
Replies: 26
Views: 1,955
Posted By dbaldwi3
Re: Snyders On-Line Ordering

I have been using Snyder’s for about six months now as for the update to their website I have likes and dislikes for the old and new sites the “wish list” was ideal the new “saved list” leaves a...
Forum: Model A (1928-31) 05-05-2019, 07:26 AM
Replies: 15
Views: 1,594
Posted By dbaldwi3
Re: Brake Rod Clevis Lubrication

I know this thread is a little old but what about permatex antisieze? I had several pins that were bound up and caused the rods to bend ?
Forum: Model A (1928-31) 04-12-2019, 04:19 PM
Replies: 5
Views: 514
Posted By dbaldwi3
Re: Floor brace

Bill the floor has been replaced with a new one and the new battery cover was purchased through Snyder’s as for a cover for the old hole there wasn’t one just a odd shaped hole in floor covered with...
Forum: Model A (1928-31) 04-11-2019, 08:35 PM
Replies: 5
Views: 514
Posted By dbaldwi3
Re: Floor brace

Bob Thanks I can’t seem to find just the rivets they only seem to sell them as a kit with the brackets. Im assuming they would be 1/4” x 1.25”?
Forum: Model A (1928-31) 04-11-2019, 06:17 PM
Replies: 5
Views: 514
Posted By dbaldwi3
Floor brace

I’m attaching a picture of the braces under the front floor board of my 1930 Tudor , are these factory or did someone just add these sometime in the past? Thanks in advance.
Forum: Model A (1928-31) 04-01-2019, 06:09 PM
Replies: 21
Views: 1,847
Posted By dbaldwi3
Re: Winch - Wench

How about “wench the winch wench!”?
Forum: Model A (1928-31) 03-23-2019, 08:03 PM
Replies: 6
Views: 1,133
Posted By dbaldwi3
Re: The Hood

Do you plan on painting the hood as one piece or disassembled? I’ve read where if it’s taken apart it can be a bear to get back together without chipping the paint, likewise if it’s painted as one...
Forum: Model A (1928-31) 03-23-2019, 06:53 AM
Replies: 21
Views: 2,182
Posted By dbaldwi3
Re: Snyders new site security concern

Go to website [url]https://snydersantiqueauto.com then login using your email and Snyder’s password then type /changePassword in address bar after .com and press enter this will take you to the...
Forum: Model A (1928-31) 03-22-2019, 06:29 PM
Replies: 21
Views: 2,182
Posted By dbaldwi3
Re: Snyders new site security concern

just tried again using a different web browser same results :(
Showing results 1 to 25 of 42

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 07:35 PM.