Go Back   The Ford Barn > Search Forums

Sponsored Links (Register now to hide all advertisements)

Showing results 1 to 25 of 500
Search took 0.06 seconds.
Search: Posts Made By: FlatheadTed
Forum: Early V8 (1932-53) Yesterday, 08:46 PM
Replies: 5
Views: 158
Posted By FlatheadTed
Re: 33-34 woodgrain difference

Nice pictures Nick
Forum: Early V8 (1932-53) Yesterday, 05:44 PM
Replies: 20
Views: 481
Posted By FlatheadTed
Re: 33 Rear Main Leak

I run that set up in one of my 34s late 35/36 block with early pan ,I don't see a problem with the vent its just immobilised, maybe more sludge .I have in it a late pump maybe 60PSI cold ,I intend to...
Forum: Early V8 (1932-53) 12-10-2019, 01:58 PM
Replies: 29
Views: 1,050
Posted By FlatheadTed
Re: 34 ford woodgrain

I have seen a super 8 movie converted to Video taken at a exposition Building possible at the 1934 Century of Progress ,this showed the graining proses plus the clear coating, It was quiet a quick...
Forum: Early V8 (1932-53) 12-09-2019, 10:14 PM
Replies: 7
Views: 231
Posted By FlatheadTed
Re: 1933 fender/bolt question?

, I said I am most likely wrong I have it noted somewhere , This was my thinking at the time I was surprised as I thought the threads would rust but then I realised with the hood up its considered...
Forum: Early V8 (1932-53) 12-09-2019, 08:47 PM
Replies: 29
Views: 1,050
Posted By FlatheadTed
Re: 34 ford woodgrain

Here's one ,
Forum: Early V8 (1932-53) 12-09-2019, 08:33 PM
Replies: 7
Views: 231
Posted By FlatheadTed
Re: 1933 fender/bolt question?

I could be wrong it was a 34 Canadian ,
Forum: Early V8 (1932-53) 12-09-2019, 07:25 PM
Replies: 29
Views: 1,050
Posted By FlatheadTed
Re: 34 ford woodgrain

I don't want to throw a Wench at the monkey but believe butler finish was the term for some plating often used on hand brakes were a minimum of polishing was desired ,34 Graining I have seen...
Forum: Early V8 (1932-53) 12-09-2019, 06:22 PM
Replies: 7
Views: 231
Posted By FlatheadTed
Re: 1933 fender/bolt question?

The fender has the nuts on the out side ,inner on the inside , if the threads are pocking in you will have real problems getting the diver in ,
Forum: Early V8 (1932-53) 12-09-2019, 01:42 PM
Replies: 20
Views: 610
Posted By FlatheadTed
Re: White wall care

I had the rear wheel of the other day and left greasy marks on the whitewall so I got some hand cleaner you know the one with sandy texture it seemed to work good ,
Forum: Early V8 (1932-53) 12-05-2019, 07:00 PM
Replies: 4
Views: 139
Posted By FlatheadTed
Re: 33 Rear Brakes

B2230 covers, A ,AA ,B ,BB, 18,40,46, I think its the same as a Model part
Forum: Early V8 (1932-53) 12-05-2019, 01:55 PM
Replies: 7
Views: 321
Posted By FlatheadTed
Re: 34 coupe floor info please

Cas ,The matt comes maybe a 1" or so past the front of the track just under the lip of the seat you need to slot it for the track ,it has a separate piece to cover the transmission and a felt /Flock...
Forum: Early V8 (1932-53) 12-04-2019, 11:03 PM
Replies: 10
Views: 511
Posted By FlatheadTed
Re: Dual Exhaust on 34 coupe

Picture,I found this somewhere could be in the States ,
Forum: Early V8 (1932-53) 12-04-2019, 02:33 PM
Replies: 15
Views: 461
Posted By FlatheadTed
Re: '38 rear brake spring - how to? @*&%^!!

Some tools don't cut it you have to improvise as you said , we have the spring pliers but on 38 brakes (can be a pain ) we use a large flat screw driver near the rivet to roll the spring off then...
Forum: Early V8 (1932-53) 12-03-2019, 03:31 PM
Replies: 19
Views: 414
Posted By FlatheadTed
Re: 1933-34 Steering Column Tube

A Exhaust shop as Cas says, could flare it ,then just drill it for the lock ,
Forum: Early V8 (1932-53) 12-03-2019, 03:09 PM
Replies: 19
Views: 414
Posted By FlatheadTed
Re: 1933-34 Steering Column Tube

You could make the flare by holding it over the edge ( maybe 1/4 to 1/2 )of a wood bench and tapping it around with a ball peen hammer ,not sure what the measurement is to the lock maybe 7"
Forum: Early V8 (1932-53) 12-03-2019, 02:34 PM
Replies: 19
Views: 414
Posted By FlatheadTed
Re: 1933-34 Steering Column Tube

What about a 32 tube ,
Forum: Early V8 (1932-53) 12-02-2019, 04:15 PM
Replies: 6
Views: 400
Posted By FlatheadTed
Re: 36 5 w

In the chassis there's a hole about 8" from the running board in the top this would be about 2-1/2 io 3' from the hinge pillar and be directly below the rubber pipe nipple .it looks like a Factory...
Forum: Early V8 (1932-53) 12-02-2019, 02:02 PM
Replies: 7
Views: 303
Posted By FlatheadTed
Re: 34 Roadster ft spring ..

The 34 spring I have here is 31-1/2 long , loaded ,3-1/4 from the centre to the top of the axle .unloaded Roadster 7" to the axle ,3" inches from the top of the 17" tyre to the fender lip .(this...
Forum: Early V8 (1932-53) 12-02-2019, 01:36 PM
Replies: 6
Views: 400
Posted By FlatheadTed
Re: 36 5 w

Should be two holes somewhere in the bottom of the A piller below the lower door hinge ,not sure how it works because it would vent out onto the top of the fender,
Forum: Early V8 (1932-53) 11-29-2019, 12:59 PM
Replies: 18
Views: 570
Posted By FlatheadTed
Re: Updating a 33/34 radio.

This is a informative thred , I would be happy just with that 34 Radio head just to fill the hole.
Forum: Early V8 (1932-53) 11-27-2019, 02:28 PM
Replies: 3
Views: 263
Posted By FlatheadTed
Re: 1934 pickup

Because the interior was not upholstered I think they painted them the one colour as I don't be leave they were into masking up any way going by the two cabs I have here one black one green,
Forum: Early V8 (1932-53) 11-26-2019, 01:02 PM
Replies: 9
Views: 280
Posted By FlatheadTed
Re: Dual horns - Wiring

The points should open and shut with the vibration of the centre shaft ,you may have a nut missing that sets the points on the small centre shaft ,this is set close and you tune it according to the...
Forum: Early V8 (1932-53) 11-21-2019, 12:07 AM
Replies: 13
Views: 430
Posted By FlatheadTed
Re: 33 engine noise

Lawry The muffler sounds like a Coby I run one but its 24" long I like the sound but its a bit loud for a long haul ,your running more horse power now so is it that ,
Forum: Early V8 (1932-53) 11-20-2019, 07:41 PM
Replies: 7
Views: 694
Posted By FlatheadTed
Re: Stock 40 Coupe

30-9 short out the plugs is it running on 7, as Allan said
Forum: Early V8 (1932-53) 11-18-2019, 09:27 PM
Replies: 60
Views: 3,527
Posted By FlatheadTed
Re: FORD vs FERRARI

Here's another clip a team effort ,the change to Goodyear tyres.
https://www.youtube.com/watch?v=fhiWRTDZ7-E&t=128s
Showing results 1 to 25 of 500

 
Forum Jump
Sponsored Links (Register now to hide all advertisements)


All times are GMT -5. The time now is 11:03 AM.